Zoned M-2 (Light Industrial): I-L (new proposed zoning based on Zoning Equivalency Table) Large Warehouse with Great visibility on Bonny Oaks Drive and within one mile of Hwy 153 for quick access to interstate 2 buildings connected by 2 roll up doors (Approximately 10’ wide x 12 ‘ high) Located 3 miles from Volkswagen Chattanooga – Perfect location for supplier Electrical system includes 3-phase, 120/240 volt, 200-amp service with split panels. Water and electric have one meter for both buildings. Gas has two meters – one for each building. Loading dock access on Building #1 but can also provide access to Building #2 Warehouses are insulated with 2 natural gas heaters in each warehouse 2 Executive offices with shower Truck dock height ~ 3’10” 6116 - Building #1 25,200 SF (per tax record) Constructed 1989 Building was originally built as Frost Cutlery office and warehouse. office building in front and warehouse in back with covered loading dock. Office is heated and cooled. Warehouse is heated with gas fired ceiling mounted heaters. Restrooms in office and restrooms in warehouse Approximately 25 parking spaces Column spacing approximately 37’ wide X 25’ deep Ceilings in warehouse are exposed steel with insulation at 26 feet at the peak. 6130 - Building #2 16,731 SF (per tax record) Constructed 1995 Built by Frost Cutlery as an addition to their warehouse Roll up door at grade for access to building #2 Two separate office areas (with separate entry doors) on front of building. Currently left side office suite is vacant. Right side office suite is owner occupied. Office is heated and cooled. W Warehouse is heated with gas fired ceiling mounted heaters. Restrooms in office and restrooms in warehouse. One known active leak in left side office area. Entire structure is full roof height but a drop ceiling has been installed over office areas. Approximately 20 parking spaces. Column spacing approximately 25’ Ceilings in warehouse are exposed steel with insulation at 26 feet at the peak. Buyer to perform due diligence to confirm all specifications.